5 GAL Water Wased High Gloss Acrylic Concrete And Paver Sealer, And Cure And Seal

5 GAL Water Wased High Gloss Acrylic Concrete And Paver Sealer, And Cure And Seal

The Armor WB25 is a water-based acrylic cure and seal designed to enhance, seal, and protect concrete and paver surfaces. It will protect the surface with a durable high gloss surface film. The Armor WB25 is a fantastic sealer if you are looking to enhance surfaces with a high gloss finish. The Armor WB25 also doubles as a cure and seal and can be applied to new concrete.The Armor WB25 is made from high quality, non-recycled, US manufactured resins. It is non-yellowing, breathable, and low VOC. The protective high gloss film will reduce damage and deterioration caused by surface abrasion and water absorption including cracking, spalling, pitting, dusting, and the growth of mold, mildew, and algae.

Features

• Meets ASTM 1315 and ASTM C 309 standards
• Protective surface film will reduce damage and deterioration caused by water absorption and surface abrasion
• Protective surface film will reduce the growth of mold, mildew, and algae on the surface
• Breathable, UV resistant, made in the USA. When properly applied, the Armor WB25 can provide up to 1-3 years of life on an exterior surface before the need to recoat, and up to 2-7 years of life on an interior surface.
• The Armor WB25 is designed specifically to be used on unsealed concrete and concrete pavers. It can also be applied to concrete and concrete paver surfaces previously sealed with a water based acrylic as long as the acrylic has been properly prepped for adhesion. The Armor WB25 should not be used to seal clay brick, red Chicago pavers, flagstone, slate, tile, or natural stone. If you are looking to seal clay brick, red Chicago pavers, flagstone, slate, or natural stone, consider instead of the Armor WL550 or the Armor SX5000 WB.
• Coverage: Porous Surfaces: Up to 175 FT2/gallon in one coat.Smooth Surfaces (once properly prepped): Up to 200-225 FT2/gallon in one coat.Coverage will vary depending on porosity, surface condition, application method, and the amount of material applied by the applicator. The above coverage rates are estimates and will vary. Two coats are suggested for even coverage and appearance.
• Application: The Armor WB25 can be applied with a 3/8-1/2” nap roller, or an HVLP sprayer. For a consistent high gloss finish, apply two coats spaced 6-8 hours apart. Do not exceed 24 hours apart between coats.

Details

Assembly

Warranty